New Energy Sources — Question 2

Section 6-6 · Chemistry pages 1009–1010

Show solutionHide solution

Question 2

Use the cubic wind-power model within its assumptions

For a hypothetical turbine, delivered power is modeled by P=12ρAv3CP=\frac12\rho A v^3 C, with air density 1.20 kg/m3^3, swept area 10.0 m2^2 and constant combined extraction/conversion factor C = 0.400. Assume operation below any power cap.

Diagram shown in the original SVG worksheet.

  1. Calculate power at wind speeds 6.00 and 9.00 m/s and their ratio.

  2. Why should this cubic prediction not be extended to arbitrarily large wind speed?

Question 2 - Solution

Use the cubic wind-power model within its assumptions

Diagram shown in the original SVG worksheet.

(a) Reasoning and result

The constant factor is 12(1.20)(10.0)(0.400)=2.40\frac12(1.20)(10.0)(0.400)=2.40. At 6.00 m/s, P=2.40(6.00)3=518.4P=2.40(6.00)^3=518.4 W. At 9.00 m/s, P=1749.6P=1749.6 W. The ratio is (9/6)3=3.375(9/6)^3=3.375, or 3.38.

(b) Analysis

Actual turbines have controls, rated-power limits and shutdown conditions; the conversion factor also need not remain constant. The supplied model only applies in its assumed operating range.

Check and interpretation

Wind kinetic-energy flux is an energy rate; the output is power, not energy over an unspecified duration.